73
English
• Whenever possible, disassemble the hinge or pivot point.
• Spray penetrating oil containing molybdenum disulphide onto the friction surfaces and allow the oil
to penetrate.
• Wipe away all traces of old lubricant and dirt.
• Should some parts not be accessible, use compressed air to remove all traces of old lubricant and
dirt from the joints and pivot points.
• When pivot points are clean, apply new lubricant.
• ELIET recommends Novatio Clear Lube as a lubricant for pivot points and rolling bearings. Novatio
PFT lubricant is more suitable for friction surfaces.
• Wipe away any excess lubricant.
11.5.8.13. Lubricating using the grease fittings
11.5.8.13.1. Grease fittings for small doses
This group includes the following
locations on the machine:
• Grease fitting on the pivot point of
swivel wheels.
• Grease fittings on the bearings of
swivel wheels.
11.5.8.13.2. Grease fittings for large doses
• Grease fittings on the rods of the feeding roller
(1)
• Transmission grease fittings in the rear rims
(2)
Use the following procedure:
• Clean the grease fitting.
• Use a suitable grease pump to inject fresh grease into the grease fitting.
• ELIET recommends using MOBILGREASE XHP222.
• Pumping the grease gun one or two times is sufficient to inject enough grease.
• Wipe away any grease that comes out of the joints.
1
2
Summary of Contents for Prof 6
Page 1: ...Prof 6 M A N U A L ...
Page 90: ...90 English ...
Page 91: ...91 English ...
Page 92: ...92 English BZ 201 450 003 ...
