26
English
9. Manual
9.1. Preliminary checks
Caution
: Before you begin working, habit to check the following points:
Checklist
1. Make sure there is enough oil in the engine. (see Section 11.4.1, page 56)
2. Ensure that there is enough petrol (UK)/ gas (USA) in the tank. If necessary, top up the tank
with petrol (UK)/ gas (USA). Keep in mind that average consumption is approximately
2.5l/h-5qt/h (see Section 9.2, page 27)
3. Check the condition of the air filter. (see Section 11.4.3, page 57)
4. Check the blades for wear and ensure that they are tightly fastened to the cutter supports. If
they need to be sharpened, this must be done before you may proceed.
(see Section 11.5.2, page 62)
If you notice that the blades or blade shaft are cracked or broken, replace them immediately.
(see Section 11.5.3.2, page 67) As a further safety measure, retighten the blade bolts.
5. Check that the belt is still sufficiently taut. If this is not the case, retighten it. (see Section
11.5.4, page 69)
6. Check whether all safety features on the machine still operate correctly.
(see Section 7.2, page 18)
Once these items have been checked and approved, you can prepare the work area
(see Section 9.3, page 28) and move the machine to the work site.
7. Monitoring tyre pressure:
• Swivel wheels: 1.5 bar
• Driving wheel: 1.5 bar
Adjust pressure if necessary.
Summary of Contents for Prof 6
Page 1: ...Prof 6 M A N U A L ...
Page 90: ...90 English ...
Page 91: ...91 English ...
Page 92: ...92 English BZ 201 450 003 ...
