72
English
11.5.8. General lubrication
Given that shredders often operate in extreme conditions, ELIET believes it is important to use
high-quality lubricants. ELIET therefore recommends the use of special lubricants from the as-
sembly stage onwards.
The following parts require regular lubrication:
• Pivot points and friction surfaces. See “11.5.8.1. Lubrication of pivot points and friction surfa-
ces”, page 72.
• Grease fittings. See “11.5.8.13. Lubricating using the grease fittings”, page 73.
• Bearings. See “11.5.8.14. Lubricating the bearings”, page 74.
• Chains and cogs. See “11.5.8.15. Lubricating the chains and sprockets”, page 75.
Caution:
Before performing lubrication operations, always make sure to switch
off the engine and remove the ignition key. Gloves must also be worn while
performing this maintenance work.
11.5.8.1.
Lubrication of pivot points and friction surfaces
11.5.8.1.1.
This group includes the following locations on the machine:
a. Wheel control handle pivot points.
b. Guiding blanking plate for the feed roller.
c. Throttle lever pivot point. Starter lever.
d. Hinges on the rear shredder hatch.
e. Safety bracket pivot points.
f. Feed roller controls.
g. Wheel brake guide.
h. Parking brake foot pedal.
i. Blow chute pivot point.
j. Hinging points on the deflector.
k. Feed roller hinges.
l. Rear wheel shafts. (Grease fittings)
Summary of Contents for Prof 6
Page 1: ...Prof 6 M A N U A L ...
Page 90: ...90 English ...
Page 91: ...91 English ...
Page 92: ...92 English BZ 201 450 003 ...
