Electroline Control Unit IV, Reference Manual

Page: 76 / 146

Subscriber Statuses Control Unit IV Reference Manual
4-6 529-0004 Ver.3
Multi-tier example
Enter the following command to display the status for the subscribers in group 32. You must
enter the first group’s number (32) followed by the total number of groups you want to
display (1). The status for the subscribers in group 32 only will be displayed.
CU4>grp 32,1
Group 32
tap 1 [off]
tap 2 [e]
tap 3 [c]
tap 4 [off]
tap 5 [bdh]
tap 6 [bdefgh]
tap 7 [abcg]
tap 8 [acd]
tap 9 [off]
tap 10 [off]
tap 11 [off]
tap 12 [off]
tap 13 [adfgh]
tap 14 [abcdfgh]
tap 15 [abcefgh]
tap 16 [acdef]
4.6 Sending an immediate group command
To force the Control Unit to send information for a specific group immediately:
1. Press <Enter> to display the CU4> prompt.
2. Type
sendgrp
<group> and press <Enter> (for example,
sendgrp 8213
).
group: 1 to maximum number of groups
The
sendgrp
forces an immediate transmission of data for a group. After the Control Unit
sends the data, it will go back to where it was in its scan cycle. To set the sequencer to a
specified group and update their status at the same time, use the
setseq
command
(see section 4.7).
4.7 Setting the sequencer to a specific group
Normally, the sequencer scans all subscribers during its scan cycle. It is possible to interrupt
the normal scan and set the sequencer to scan starting from a particular group number.
To position the sequencer on the specified group and update it at the same time:
1. Press <Enter> to display the CU4> prompt.
2. Type
setseq
<group> and press <Enter> (for example,
setseq 2132
).
group: 1 to maximum number of groups