Electrohome VistaGRAPHX 2500, User Manual

Page: 16 / 101

INSTALLATION & SETUP
VistaGRAPHX 2500 User's Manual
2-13
Figure 2-13. Power Connection
WARNING:
Do not attempt operation if the AC input is not within
the specified input range.
Caution: Once the projector is turned off, the lamp cooling fans will continue to
run for approximately five minutes to ensure that the projector and lamp have
sufficiently cooled, at which point the fans will automatically shut off. To avoid
damaging the projector, never unplug the line cord while the lamp cooling fans
are running. Do not unplug the projector in order to power down.
VistaGRAPHX 2500 is set up at the factory for use in a front screen, floor mount
orientation. If the installation is ceiling mount or rear screen, you may notice that
displayed images are upside down and/or reversed. To correct, you must change
the image orientation from within the Preferences menu (you may prefer to do
this before physically
installing the projector). See
Section 3, Operation for
further information.
In the Preferences menu,
highlight and select the
"Image Orientation" pull-
down list. From a front
screen floor mount
installation, select from
Rear, Inverted Rear, Front
or Inverted Front according
to your intended installation:
For most installations, the lens surface
of the VistaGRAPHX 2500 projector
must be parallel to the screen to
prevent keystoning. To make small
corrections to the projector's level,
rotate each leg as necessary to raise or
lower.
2.6 Operating
Orientation
2.7 Leveling