Efficient Networks
®
Router family
Command Line Interface Guide
Chapter 4: System Commands
Efficient Networks
®
Page 4-51
system selnat addpolicy
Configures selective NAT policies. Selective NAT translation is performed based on
destination address defined in the policy. For more information, refer to ”
Selective
NAT” on page 4-30
of the Technical Reference Guide.
Mgmt Class
Network (R/W)
Input Format
Two commands are used to create policies; the first (below) specifies translation of
the private address, the second will specify no translation is performed.
system selnat addpolicy <remote addr> <remote addr mask> trans
<public addr>
system selnat addpolicy <remote addr><remote addr mask> notrans
Parameters
Examples
Response
Command prompt.
<remote addr>
a
a
Dotted-decimal notation
Specifies the destination IP address to which the policy
will be applied.
<remote addr mask>
a
Speficies the destination IP network mask to which the
policy will be applied.
<public addr>
a
Specifies the resulting public address to which private ad-
dress will be translated.
This command will create a policy translating the source address to 64.35.6.1 for
packets destined for any address in the 12.16.32.0 subnet.
-> system selnat addpolicy 12.16.32.0 255.255.255.0 trans
64.35.6.1
This command creates a policy that speficies no translation is performed for
packets destined for the adress of 10.2.2.2.
-> system selnat addpolicy 10.2.2.2 255.255.255.0 notrans
