Efficient Networks
®
Router family
Command Line Interface Guide
Chapter 6: Remote Commands
Efficient Networks
®
Page 6-17
remote delatmsnap
This command deletes an ATM mapping set by the
remote setatmnsap
command,
page 40.
Mgmt Class
Network (R/W)
Input Format
remote delatmfasp atmf | e164 partial | full <nsap>
<remotename>
Parameters
Response
Command prompt.
remote delbridge
Removes the designation of the remote router entry as the default bridging
destination. (Default bridging destinations are defined using the
remote addbridge
command.) To see the bridge settings for a remote entry, use the
remote listbridge
command.
To remove a designation as the default bridging destination for a specific MAC
address, specify that address on the command. The entry is then removed from the
bridging table. To see the entries in the bridging table, use the
bi list
command.
Mgmt Class
Network (R/W)
Input Format
remote delbridge * | <mac_addr> <remotename>
atmf
ATM forum encoding.
E164
ITU E164 encoding.
partial
The MAC address of the router is substituted for octets 2-7 of the NSAP.
full
No change is made to the specified NSAP.
<nsnap>
a
a
specified as 40 hex digits or 20 octets (2-digit pairs separated by colons
NSAP
