Efficient Networks
®
Router family
Command Line Interface Guide
Chapter 6: Remote Commands
Efficient Networks
®
Page 6-3
remote disauthen
This command is intended for situations where third-
party routers cannot be authenticated; the target router
will not attempt to authenticate the remote router.
remote disbridge
Disables bridging from the target router to the remote
router.
remote enaauthen
Initiates the target router authentication negotiation as
defined in the remote router’s database.
remote enable
Enables use of an entry in the remote router database.
remote enabridge
Enables bridging from the target router to the remote
router.
remote ipfilter
Manages the IP filters on the WAN interface.
remote list
Lists the remote router entry (or all the entries) in the re-
mote router database.
remote listbridge
Lists the current bridge settings for the specified remote
router entry.
remote listiproutes
Lists IP information for a remote router or, if the router
name is omitted, for all routers in the remote router da-
tabase.
remote listipxroutes
Lists all network IPX route addresses defined for the
LAN connected beyond the remote router.
remote listipxsaps
Lists all services defined for the LAN connected beyond
the remote router.
remote listphones
Lists the PVC numbers available for connecting to the
remote router.
remote restart
Stops the current active session and starts a new active
session for a remote.
remote setatmnsap
RFC1577 (Classical IP over ATM) specifies a mecha-
nism to map an ATM Name (called an SNAP) to a PVC.
remote setauthen
Sets the authentication protocol used communicate with
the remote router.
remote setbod
Sets the bandwidth on demand (BOD) management op-
tion for a DOD (dial on demand) connection, that is, a
connection where the link goes up and down.
remote setbroptions
Sets controls on bridging for the remote router entry.
remote setbwthresh
Sets the bandwidth threshold for a DOD (dial on de-
mand) connection, that is, a connection where the link
goes up and down.
Table 6-1: Remote Command Listing (Cont.)
Command
Function
