97
Practical Use of the PR-50
Using Other Devices to Control Presenter
When controlling the PR-50 from an external device, set the PR-50 to Play mode (p. 37). In Edit mode,
only the DV-7DLC transport control, In and Out point settings, and mouse and keyboard functions
are enabled. No other controls can be controlled from an external device.
Using a DV-7DLC
You can use an optional DV-7DLC to control clips with the kind of intuitive operation that only a
dedicated controller can provide. Use the cable included with the PR-50 to connect the DV-7DLC to
the PR-50’s front panel or the [REMOTE] connector on the rear panel.
Connect devices only with the power turned off.
Do not connect more than one DV-7DLC.
Displaying the Color Bar, Switching Play Mode and Edit Mode,
and Turning Off the Power
The following operations are common to each of Presenter’s modes.
Displaying the Color Bar
Hold down the [SHIFT] button at the lower right and press the [COLOR BAR] button.
To stop display of the color bar, perform the same operation again.
Switching Play and Edit Modes
Hold down the [SHIFT] button at the lower right and press the [MODE] button.
Turning Off the Power
Hold down the [SHIFT] button at the lower right and press the [OFF] button near the center.
You cannot perform this procedure twice in rapid succession while holding down the [SHIFT] button
at the lower right.
Making the Clip Settings
PR-50_e.book 97 ページ ２００６年１１月２日 木曜日 午後６時２９分
