Eddyfi Technologies Floormap X, User Manual

Page: 62 / 106

SIMS GO
62
scanner.
6. Click OK then perform the scan.
NOTE
Once data acquisition has been performed the position of the scan on the plate cannot be
altered.
Load Scan
The load scan button allows captured scans to be viewed in the Scan View section of the software.
Scans can be loaded by either selecting a scan from the plate view then clicking
Load Scan or by
cycling through each scans using the arrows in the bottom right-hand side of the plate view screen.
Figure 78: Selected scan number
Scan Options
The scan options button allows the user to deviate from a pre-planned scanning pattern by selecting
a different track to scan, changing the scan direction, or by altering the start scan offset value.
Figure 79: Scan options
Track
Track selection: allows track number selection. An icon to the right indicates track type.
Scan Direction
Scan Direction: allows the scan direction to be specified. The original direction refers to the direction
determined by the pre-planned scanning.
NOTE
When the scan direction is altered the option is remembered for consecutive scans.
Start Scan Position
The user can specify one of the following start positions:
•
Track Origin: an offset value based on the distance from the plate edge to the track origin. By
default, the offset value is the dead zone of the scanner.