2
May 1997 – 5B6729
PLEASE NOTE
The information contained herein is based on the experience and knowledge relating to the
subject matter gained by Eastman Kodak Company prior to publication.
No patent license is granted by this information.
Eastman Kodak Company reserves the right to change this information without notice, and
makes no warranty, express or implied, with respect to this information. Kodak shall not be liable
for any loss or damage, including consequential or special damages, resulting from any use of
this information, even if loss or damage is caused by Kodak’s negligence or other fault.
Warning
To avoid hazardous conditions, keep floors and floor coverings around your
Kodak X-Omat Processor and
associated drains clean and dry at all times. Any accumulation of fluids from mixing tanks, drain lines, etc, should
be cleaned up immediately. In the event of an accumulation of liquid due to backup, overflow, or other malfunctions
of the drain associated with your
Kodak X-Omat Processor, call a plumber or other contractor to correct any problem
with the drain. Kodak accepts no responsibility or liability whatsoever for the serviceability of any drain connected to
or associated with a
Kodak X-Omat Processor. Such drains are the sole responsibility of the customer.
Description
Page
Table of Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5
Identifying the Covers and Panels and Other Components of the Processor
6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7
Adjusting the Contrast of the Display Panel
. . . . . . . . . . . . . . . . . . . . . . . . . . .
8
Enabling the Auto Dimming Feature
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8
Adjusting the Intensity of the Interface Control Panel
. . . . . . . . . . . . . . . . . . . .
8
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9
Limiting Access to the Processor Setup
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
11
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
11
Operating Characteristics
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
12
13
Performing the Daily Start-Up Procedure
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
13
Performing the Shutdown Procedure
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
14
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
15
Default Setpoints and Configurations
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
17
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
17
19
Selecting a Film Processing Cycle
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
19
Procedure for Selecting the Rapid, Standard, or Extended Cycle:
20
Procedure for Selecting the K/RA Cycle:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
20
Setting the Dryer Setpoint Temperature
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
22
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
23
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
25
Calibrating the Replenishment System
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
26
Selecting a Replenishment Mode
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
28
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
30