OPERATORS MANUAL
42
May 1997 – 5B6729
[7] One of the following 2 screens will appear. Press the key for the desired film processing cycle.
[8] Press the “TEMP” key.
[9] Press either key:
• the “DEV TEMP” key to change the developer setpoint temperature
• the “FIX TEMP” key to change the fixer setpoint temperature
[10] To change the setpoint temperature, press the appropriate key:
• [
▲
] key to increase the setpoint temperature
• [
▼
] key to decrease the setpoint temperature
• [DEFAULT SETTING] to return to the default setpoint temperature
• [CANCEL REQUEST] to cancel the procedure
[11] Do Steps
for the fixer (or the developer) solution.
[12] Press the “DONE/RETURN” key repeatedly until you return to the display shown below. Then press the “YES”
key to return to the Walk-Up Menu.
Note
The setpoint temperature for the fixer solution is a minimum only; the temperature may rise above this setpoint.
PRESS BUTTON TO SELECT
RAPID
CYCLE
STD CYCLE
EXTD
CYCLE
DONE/
RETURN
PRESS BUTTON TO SELECT
K/RA
CYCLE
DONE/
RETURN
TEMP
REPLEN
VOLUME
SPEED
DONE/
RETURN
DEV
TEMP
FIX
TEMP
DONE/
RETURN
95.0 F = DEVELOPER SETPOINT
STD
▲
▼
DEFAULT
SETTING
CANCEL
REQUEST
DONE/
RETURN
EXIT SETUP?
YES
CANCEL
REQUEST
