E-Z-GO MPT 800, Technician'S Repair And Service Manual

Page: 68 / 212

ELECTRONIC SPEED CONTROL (36V)
Page F-2
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings
Socket, 3/8", 3/8" drive ................................................ 1
Ratchet, 3/8" drive ....................................................... 1
Torque wrench, in. lbs., 3/8" drive ............................... 1
Torque wrench, ft. lbs., 3/8" drive ................................ 1
Extension, 6", 3/8" drive .............................................. 1
Insulated wrench, 9/16" ............................................... 1
Wrench, 1/2"................................................................ 1
Wrench, 7/16".............................................................. 1
Phillips screwdriver, large ............................................ 1
Phillips screwdriver, small ........................................... 1
Shop towel................................................................... 1
Allen wrench, .050" ..................................................... 1
Symptoms
Vehicle does not operate, operates poorly or intermit-
tently.
Testing
It is unlikely that the mechanical adjustment of the pedal
box has changed, therefore the initial tests will be con-
ducted with a digital volt ohm meter (DVOM) to identify
the failed component.
A typical DVOM is shown in illustrations. A recom-
mended DVOM is available through the E-Z-GO Service
Parts Department as P/N 27481-G01. Any DVOM may
be used; however, the accuracy, controls, displays and
features may vary depending on the make and model.
Always follow the meter manufacturer’s recommenda-
tions and instructions for the use and care of the meter.
To assure accurate readings, be sure to set the meter to
the closest voltage reading above the expected voltage.
To prevent injury result-
i ng f r o m u n e x p e c t e d
movement of the vehicle,
always raise the rear wheels before conducting any
tests.
To prevent possible motor damage, never operate
vehicle at full throttle for more than 4-5 seconds while
vehicle is in a “no-load” condition.
Raise the rear wheels of the vehicle and support on jack
stands (Refer to the Lifting Procedure in Section ‘B’
Safety). Test the vehicle stability before proceeding.
Place the direction selector in ‘F’ and turn the key switch
to ‘ON’. Depress the accelerator pedal until the micro
switch in the pedal box activates which should cause the
solenoid to make an audible click.
Testing Battery Voltage
It is important to determine the condition of the battery
set before proceeding with any electrical troubleshooting.
An open voltage test is of little use since a battery that
has deteriorated to the point of requiring replacement
can still show six volts or higher in an open voltage test. If
there is any doubt as to the adequacy of the battery set,
charge the batteries and perform a load test using a dis-
charge machine following manufacturers instructions. If
batteries are satisfactory, recharge battery set.
With the adequacy of the batteries confirmed, use a
DVOM connected directly to the battery terminal posts to
determine the open voltage of the set (Ref Fig. 3 on page
F-2). In the following tests, this voltage level will be used
as a reference. Some loss due to resistance or wires and
connectors may be indicated by readings that could be
up to one volt less than the reference voltage. No reading
indicates an “open” condition and the battery wires
should be inspected for a broken or disconnected wire or
component.
! !
Fig. 3 Battery Reference Voltage
v
?
Battery
Reference
Voltage
Positive Probe
to BL+
Negative Probe
to BL-