Dynapac CC1000 e, Instruction Manual

Page: 89 / 130

Miscellaneous
4812164901_A.pdf 2022-11-14
Load carrier Load carrier
- When loaded, the vibratory roller is centered laterally on the platform (± 5 cm). - When loaded, the vibratory roller is centered laterally on the platform (± 5 cm).
- The parking brake is applied and in good working condition, and the articulated joint lock is
closed. - The parking brake is applied and in good working condition, and the articulated joint lock is
closed.
- The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6. - The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6.
- The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a
risk of frost, ice and/or snow the platform has to be salted. - The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a
risk of frost, ice and/or snow the platform has to be salted.
- The lashing mounts on the load carrier have LC/MSL at least 2 tonnes. - The lashing mounts on the load carrier have LC/MSL at least 2 tonnes.
Lashings Lashings
- The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.6
tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport. - The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.6
tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport.
- Each of lashings 1-2 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different lashing points on
the platform. - Each of lashings 1-2 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different lashing points on
the platform.
- Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however. - Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however.
- The lashings are as short as possible. - The lashings are as short as possible.
- The lashing hooks must not lose grip if the lashings become slack. - The lashing hooks must not lose grip if the lashings become slack.
- The lashings are protected against sharp edges and corners. - The lashings are protected against sharp edges and corners.
- The lashings are located symmetrically in pairs on the right and left sides. - The lashings are located symmetrically in pairs on the right and left sides.
Towing/Recovering
The roller can be moved up to 300 meters (330 yards)
using the instructions below.
1
Fig. Drum
1. Propulsion motor, located left
front and right rear.
Activate the parking brake and switch off the
machine (as described in chapter "Switching off").
Chock the drum to prevent the roller from moving
when the brakes are disengaged. Activate the parking brake and switch off the
machine (as described in chapter "Switching off").
Chock the drum to prevent the roller from moving
when the brakes are disengaged.
The brakes in each propulsion motor must be
mechanically released, as described below,
before the roller is towed. The brakes in each propulsion motor must be
mechanically released, as described below,
before the roller is towed.
79