Dynapac CC1000 e, Instruction Manual

Page: 127 / 130

Maintenance - 2000h
4812164901_A.pdf 2022-11-14
Water tank - Cleaning
Fig. Bay under the floor
1. Drainage tap
2. Water filter
3. Water pump
1
2
3
Keep in mind that there is a risk of freezing in
winter. Drain the tank, pump and lines. Keep in mind that there is a risk of freezing in
winter. Drain the tank, pump and lines.
Drain the tank through the drainage tap (1) alongside
the filter.
Clean the tank with water and a suitable detergent for
plastic surfaces.
Clean the water filter (2). Fill the tank with water and
check that the sprinkler functions.
The water tank is made of plastic (polyethylene)
and is recyclable. The water tank is made of plastic (polyethylene)
and is recyclable.
Drum - Changing the oil
Park the roller on a level surface, and drive the roller
slowly until the plug (1) is in the bottom position.
Fig. Drum, vibration side
1. Oil plug (1) in position for draining
the oil.
2. The oil plug position for level check
and filling.
1
2
Switch off the battery and press down the
emergency stop. Switch off the battery and press down the
emergency stop.
Use the following protective equipment: Use the following protective equipment:
Safety glasses Safety glasses
Ear protectors Ear protectors
Place a receptacle that will hold at least 4 liters (1 gal)
under the plug.
Remove the plug (1) and let the oil run out.
Hand in the drained oil to a waste disposal station. Hand in the drained oil to a waste disposal station.
Refit the plug. Top up with new oil in position 2.
117