DURKOPP ADLER 512/532, Operating Instructions Manual

Page: 90 / 100

Troubleshooting
88 Operating Instructions 512/532 - 05.0 - 04/2018
E 4 2 Enlargement
error Sewing length is beyond
10 mm • Press the Reset button.
• Check the seam
appearance and the X/Y
scaling.
E 4 5 Seam
appearance
data error Seam appearance data
could not be accepted • Press the Reset button.
• Check the ROM.
E 5 0 Pause Reset button pressed while
sewing.
Sewing machine stopped. • Press the Reset button.
• Trigger the thread cutter.
• Start the sewing process
anew.
E 3 0 2 Supper section
error Upper section is tilted over. • Tilt the upper section
back into place.
E 3 0 5 Thread cutter
position error Thread cutter knife not in the
home position • Main power switch OFF.
• Check the sensor.
E 3 0 6 Thread catcher
position error Thread catcher not in the
home position • Main power switch OFF.
• Check the sensor.
E 3 3 2 Clamp foot
position error Clamp foot not in the home
position • Main power switch OFF.
• Check the sensor.
E 5 0 1 Data read error Data not present or stored in
the wrong format • Store the data anew on
the USB stick.
E 5 0 2 USB read error MOT file faulty • Store the data anew on
the USB stick.
E 5 0 3 SUM read error CHECKSUM data in MOT
file faulty • Store the CHECKSUM
file anew on the USB
stick.
E 5 0 4 Endblock error No Endblock in the MOT file • Store the Endblock file
anew on the USB stick.
E 5 0 5 USB read error USB stick not found • Main power switch OFF.
• Main power switch ON.
• Plug in the USB stick
again.
E 5 0 6 USB read error Reading from U01 ~ U10 not
possible. • Main power switch OFF.
• Main power switch ON.
• Plug in the USB stick
again.
Error message Description Possible cause Remedy