DTM System cloud FLEX, Installation And Service Manual

Page: 8 / 40

8
Failed assigning of the remote can be caused by:
 low battery of any of the remotes;
 radio noise which could appear during the process of remote assigning;
 full memory of the receiver (attempt to assign 10.000
th
remote);
 different types of remotes used.
The remote after assigning inherits the settings of the old remote which took part in the assigning process. If the
remote with admin function switched on was used then individual blockade of remote assigning is automatically switched
on in the new remote.
4.4. Adding a remote control with the Galactic function
The Galactic function allows for remote adding of remotes programmed outside the installation, without the
need for physical access to the receiver buttons. The condition for successful adding is to have a remote with the Galactic
function, with an authentication code set, consistent with the code set in the receiver.
To add a remote control with the Galactic
function, being within the radio range of the receiver:
 press and hold any two buttons on the
remote control for 5 seconds
 activate the remote control in the system
by pressing any button
The added remote control works immediately in
accordance with the programmed settings.
Unsuccessful adding of the remote control may be caused by:
 incompatibility of the authentication codes of the receiver and the transmitter;
 radio interference that may have occurred during the procedure;
 the receiver's memory is full (attempt to enter 10.000 remote control);
 low battery of the remote control.
Rys. 6 Adding a remote with Galactic function.
REMOTE IN RECEIVER RADIO
RANGE
REMOTE IN RECEIVER RADIO
RANGE
PRESS AND HOLD FOR 5s
TWO BUTTONS
PREACTIVATE BY
PRESSING ANY BUTTON