17
5.2.2. PC.CH – Pulse mode programming
Activating this function (Fig.16) causes setting the chosen channel into the pulse mode i.e. transmitter is
activated for the time of pressing the button of the remote. In case of channel operating in pulse mode, one-time
activating of the channel can take place to a maximum of 2 minutes. After this time the signal transmission from the
remote is stopped to protect the battery. In order to continue the operating of the channel it is necessary to press the
button of the remote again.
To activate pulse mode it is necessary to:
in main menu with NEXT button choose PC option and press OK/ESC button of the receiver, the display shows
‘PC.C1';
with NEXT button choose PC.CH option and [press OK/ESC button;
the display shows 'CH.Cx' where 'x' is a number of configured channel. If the channel is to operate in pulse mode
it is necessary to se in front of the channel number x sign "C" ('Cn.Cx' with the NEXT button),if the channel is not
to operate in pulse mode it is necessary to set "_" ('CH._x'); the change of edited channel number is done with
longer pressing of NEXT button.
At any time it is possible to withdraw from the edition by pressing and holding OK./ESC button of the receiver.
Fig. 16
Programming of pulse mode of receiver channels, PC.CH function in main menu of the receiver.
Summary of Contents for cloud FLEX
