Draytek Vigor3910 Series, User Manual

Page: 616 / 627

Vigor3910 Series User’s Guide 606
wan modem wakeup [on/off/value]
wan modem vid [id]
wan modem pid [id]
wan modem status
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
init Set initial modem AT command (default value is
“AT&FE0V1X1&D2&C1S0=0”).
Init2 Set the second initial modem AT command.
dial Set dial modem AT command (default value is “ATDT*99#”).
pin Set PIN code for SIM card.
“0”:disable
paponly It means PAP Only. Set the PPP authentication of the USB WAN.
on: None.
off: PAP or CHAP.
backup_wait Set waiting time after boot if USB WAN is in backup mode. This
waiting time is reserved for the dial of main WANs so that the
backup USB WAN will not go up first.
Available setting is from 1 to 255. Unit is second.
pipe It is for RD debug only. Please don’t use it without our advice.
wakeup [on/off] It is for RD debug only. Please don’t use it without our advice.
vid Set VID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
pid Set PID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
status Display current status of USB modem.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wan modem pin 0000
> wan modem status
Modem Link Speed=0
Current Signal Strength=0
Last Fail Message:
Current Connect Stage:
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
a
a
n
n
d
d
e
e
t
t
e
e
c
c
t
t
This command allows you to Ping a specified IP to detect the WAN connection (static IP or
PPPoE mode).
S
S
y
y
n
n
t
t
a
a
x
x
wan detect [wan1][on/off/always_on]
wan detect [wan1]target [ip addr]
wan detect [wan1]ttl [1-255]
wan detect status