Draytek Vigor130, User Manual

Page: 242 / 288

Vigor130 Series User’s Guide 232
timeout.
-s <sec> It means “TCP SYN” protocol.
<sec>: Type a number to set the TCP SYN session timeout.
-f It means to flush all portmaps (useful for diagnostics).
-l <List> List all settings.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> portmaptime -t 86400 -u 300 -i 10
> portmaptime -l
------ Current setting ------
TCP Timeout : 86400 sec.
UDP Timeout : 300 sec.
IGMP Timeout : 10 sec.
TCP WWW Timeout: 60 sec.
TCP SYN Timeout: 60 sec.
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
q
q
o
o
s
s
s
s
e
e
t
t
u
u
p
p
This command allows user to set general settings for QoS.
qos setup [-<command> <parameter> | ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
[<command>
<parameter>|…] The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-h Type it to display the usage of this command.
-m <mode> It means to define which traffic the QoS control settings
will apply to and eable QoS control.
0: disable.
1: in, apply to incoming traffic only.
2: out, apply to outgoing traffic only.
3: both, apply to both incoming and outgoing traffic.
Default is enable (for outgoing traffic).
-i <bandwidth> It means to set inbound bandwidth in kbps (Ethernet WAN
only)
The available setting is from 1 to 100000.
-o <bandwidth> It means to set outbound bandwidth in kbps (Ethernet WAN
only). The available setting is from 1 to 100000.
-r <index:ratio>
It means to set ratio for class index, in %.
-u <mode> It means to enable bandwidth control for UDP.
0: disable
1: enable
Default is disable.