EN
PHANTOM CSF Instructions Troubleshooting:
Why won’t the cure station turn on?
• Check the exterior plug connection.
• Check the fuse box in the plug power box.
The UV lights will not turn on?
• Check the limit switch connection is securely connecting to the door. You can adjust the contact
pressure by adjusting the positioning nuts.
• Inspect wiring of the limit switch for proper connection.
• Move a functional light from another slot into the slot where a non-working light is. This will check if the
issue is with the UV light itself, or with the light clips.
• Order NEW UV lights through customer service at [email protected]. Light specifications
are specific to the PHANTOM Cure Station and no other lights should be used other than DPS provided.
Why is the wipe down ‘chunky’?
• The PHANTOM formula is starting to gel, this can occur in some environmental conditions. Wipe off all
PHANTOM residue, and reduce the soak period to 10 minutes for future applications.
What do I do if the bases are still wet after 20 minutes curing in the cure station?
• Take the skis/board out, and using a fresh paper towel wipe down any wet areas. Place the skis/board
back in the Cure Station for another 5 - 10 minutes, or until the base(s) are 100 % dry.
• For future applications more vigorously wipe off the excess PHANTOM residue (post soak and pre cure)
leaving no pooling.
What do I do if the Cure Station won’t reach ‘Ready to Cure’ temperature?
• Check all 4 x UV lights are functional.
• Check the fan is running, you should be able to hear a ‘whirr’.
• Check the seal between the main body of the box and the door is tight.
• Be mindful of how often or how long you open the door.
• Start the preheat cycle before prep work on the skis.
• Make sure your ambient shop temperature is within reason.
The bases look a little white after curing and brushing?
• The base could be heavily oxidized or abrasion damaged with micro-hairs. Polishing with fibertex or
other abrasives can help this, or the bases need a new stone grind to remove the damaged surface.
• You may not have brushed enough of the PHANTOM topical residue off. Continue brushing, followed by
aggressive polishing with finer brushes or fibertex along with water.
