DP Pumps Hydro-Unit Utility Line F, Installation & Operating Manual

Page: 75 / 96

75
/
96
Parameter Description Value range and dependencies Factory setting Access level Read Access level Write Re-start
required
2-4-2-6 Ramp down time 0 … 60 s 0 Everybody Service -
2-4-3 Changeover from jockey pump to
base load pumps - - Everybody Service -
2-4-3-1 Over-/undersupply Oversupply Oversupply Everybody Service -
Undersupply
2-4-3-2 Time of over-/undersupply 0 … 60 s 10 s Everybody Service -
2-4-4 Check run - - - - -
2-4-4-1 Check run Disabled Enabled Everybody Service -
Enabled
2-4-4-2 Function Idle time dependent Time-dependable Everybody Service -
Time-of-day configured
Triggered check run
2-4-4-3 Duration 0 … 600 s 10 s Everybody Service -
2-4-4-4 Standstill time 0: 00: 00: 00 … 7: 00: 00: 00 d: hh: mm: ss 24 h Everybody Service -
2-4-4-5 Time stamp for activation (hours) Day of week, time Mo, 12: 00: 00 Everybody Service -
2-4-4-6 Time stamp for execution (minutes) Day of week, time Mo, 12: 00: 00 Everybody Service -
2-4-5 Short pressure deviations - - - - -
2-4-5-2 Delay time for pump start 0 … 60 s 0 Everybody Service -
2-4-5-3 Delay time for pump stop 0 … 60 s 0 Everybody Service -
2-4-6 No-flow detection - - Everybody Service -
2-4-6-1 Pump speed for activation 0 % … 100 % 1 Everybody Service -
2-4-6-2 Time within bandwidth 0 … 600 s 15 s Everybody Service -
2-4-6-3 Step interval 0 … 600 s 15 s Everybody Service -
2-4-6-4 Step height of speed 1 % … 50 % 0,03 Everybody Service -
2-4-6-5 Bandwidth 0 … bandwidth 0.05 bar Everybody Service -
2-4-6-6 Speed for stopping last pump 0 % … 100 % 0 Everybody Service -
2-4-7 Dynamic pressure setpoint
compensation - - - - -
2-4-7-1 Dynamic pressure setpoint
compensation Disabled Disabled Everybody Service -
Enabled
2-4-7-2 Maximum discharge-side pressure
deviation -10 bar … 10 bar 0 Everybody Service -
2-4-8 Motor circuit breaker - - - - -
2-4-8-1 Trigger active high/low Active high 1: Active low Everybody Service -