3. Follow instruction steps 4, 5 and 6 in the preceding
section.
4. Always use centering plates (3) to center and fin-
ish the facade sleeve.
Converting an existing flue
If the home already has a chimney, you can lead the
concentric duct system through the existing chimney
pipe. You can also convert the existing pipe into a con-
centric pipe using a single-wall flexible hose and the
right pipe reducers. There is a conversion kit for this.
See the chapter “Installation requirements” for the con-
ditions under which this conversion is permitted.
The conversion kit must be ordered separately.
The following parts are required to convert an existing
flue into a closed system; see next figure.
1
The hearth or stove to be connected
2
Concentric duct, 100/150 mm, modular
3
Installation plate inside, square 300 mm
4
Single-wall slide, round diameter 97 mm
5
Parker screws (4 pc)
6
Flexible stainless steel 316L hose, single-
wall round diameter 100/107 mm (heat res-
istance 600°C)
7
Stainless steel hose clamp reach diameter
90 to 165 mm
8
Existing chimney or flue pipe
9
Installation plate outside, square 300 mm
10
Clamping strap (included in delivery of part
11)
Subject to change because of technical improvements
11
Summary of Contents for ASTRO4GA - P
