DOGA MDT Series, Instruction Manual

Page: 72 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 72
ERROR CODE
10.1 System error
Code Error message Description How to reset
105
Transducer sensor
error
Transducer sensor problem.
Power reset.
If error remain , check the
transducer sensor
109 Over current Over current during driver run.
110 AD offset error
Over the option range of system AD,
when turn on power
Re-boot. If repeat same
error, need to repair
111 Under voltage Low voltage from SMPS power source.
Check the 14P cable state
and connection
112 Over speed
Over speed happened during driver
run.
Re-boot, Check the 14P
cable state and
connection.
113 Driver data read Fail to reading parameter data
Re-boot, Check the 14P
cable state and
connection..
114
Screwdriver recognition
error
Parameter mismatch driver to controller
Select correct driver model
in controller menu
115
Controller recognition
error
Occurs when the controller model
cannot find the specifications set in the
program Select correct driver model
in controller menu. Check
the 14P cable state.
116
Com error related with
I/O data
Fail to read I/O data from system. Re-boot.
117
Driver communication
fail
Driver communication fail
Check the 14P cable state
and connection.
118 No motor rotation error Motor did
n’t run
Reset and re-boot.
120
Barcode read/wirte
error
Barcode data R/W fail in memory Re-Boot
121 Ethernet data send fail Ethernet data send fail.
122 SD card removed SD card removed.
123 SD card save fail SD card save fail Check SD card slot
124 SD card fail Error occur in sd card process.
Check SD card slot, SD
card check
125 No Ramp up torque
Torque is not increase in ramp up speed
section
200
Parameter reading
failure
It failed to read parameter at all.
Check the EEP-ROM damage or
communication failure
201
Parameter Checksum
error The read parameter is wrong by the
checksum routine
220
Multi-sequence
program error
Multi-sequence program is wrong
Multi-sequence program is
wrong