DOGA MDT Series, Instruction Manual

Page: 38 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 38
7.6.2 Engaging Torque detection
It is possible only when the screw engaging provide significantly higher torque than previous free
run.
Speed
Unit Range Initial
rpm Tool range 0
Description Tool rotation speed
Torque
Unit Range Initial
% 0 ~ 50 0
Description Engaging torque setting by percentage of target torque
–
detection will
be active from this value
Angle limit
Unit Range Initial
0.1 turn 0 ~ 20 0
Description Max engaging rotation in rev
Time limit
Unit Range Initial
sec 0 ~ 10 0
Description Max engaging timelap
Angle start from engaging
Unit Range Initial
YES - NO NO
Description If select, the monitoring angle count is reset and start again from
engaging torque detection.point.
7.6.3 Angle after torque up
It manage extra angle control in both forward or reverse direction after tightening by torque.
Speed
Unit Range Initial
rpm Tool range 0
Description Driver rotation speed
Angle
Unit Range Initial
degree 0 ~ 15000 0
Description Rotation angle
Direction
Unité Range Défaut
Forward - Reverse Forward
Description Angle rotation direction