DOGA MDT Series, Instruction Manual

Page: 40 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 40
7.7 Multi Sequence settings
Multi sequence provide a cycle of fastening by a start signal.
Total 10 steps of programing is allowed in MA(Multi A) and
MB(Multi B) presets
To program, select the command and required parameter on
each step.
To finish the multi sequence programing, last step command
should be “END”
For screw counting and I/O’s
connexions, please use Models
◆
Command details
Command Description Data (range)
NOP No operation No use
Fastening tool start fastening process in forward rotation -
Selected Preset is fill in Data field Preset selection 1 to 15
Loosening tool start loosening process in reverse rotation Angle in 0.1 turn up to 999
Select preset# Select preset # (not mandatory ) Preset can be
selected in data of Fastening command. Preset selection 1 to 15
Delay time delay for setting time 1 to 999
Jump Move to the setting step 2 to 9
Count value = A
Total number “A” to count
1 to 999
Sub if (A)
Subtract 1 from “A” and save the value replacing “A”
. If the value “ A” is not “0”, then move to the next
lower step. If the value “ A” is “0”, then move to 2
nd
lower step
No use
End Finish multi-sequence process (mandatory) No use
Be carreful : Data can be set from 0 et 999. Please set correct value in fields
Example : please refer to ParaMon Instruction Manual