DOGA MDT Series, Instruction Manual

Page: 46 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 46
Driver ID
Unit Range Initial
1 ~ 99 1
Description MDC ID used to identify ethernet data communication.
Driver model
Unit Range Initial
Screwdriver list Unknown
Description Screwdriver model : to be specified to pair screwdriver with controller
else driver is looked and Err114 is displayed
Torque unit
Unit Range Initial
Kgf.cm ~ Lbf.ft N.m
Description Kgf.cm / Kgf.m / cNm / Nm / ozf.in / lbf.in / lbf.ft
Whenever the unit is changed, all parameters are initialized and
controller should be reboot..
Password
Unit Range Initial
0 ~ 20000 0
Description Password to access controller menu
Factory setting password is ‘0’ at the initial.
Controller parameter initialize
Unit Range Initial
0 to 20000 0
Description
Key in ‘77’ and press enter button.
Flash the parameters back to factory settings - screwdriver is paired to
controller.
Autospeed
Unit Range Initial
OFF- ON YES
Description ON : Provide the safe speed on the torque setting (P1 ~ P15).
The speed is automatically calculated
OFF : speed can be set manually within the screwdriver speed range
Acceleration
Unit Range Initial
ms 10 ~ 1000 150
Description Slow start of motor to the target speed.
Torque holding time
Unit Range Initial
ms 1 ~ 20 2
Description Timelap torque is maintained after torque
Use max torque for reverse
Unit Range Initial
OFF- ON NO
Description OFF : max loosening 20% selected preset torque target
ON : full power loosening.
Loosening speed
Unit Range Initial
rpm Tool range ½ Max tool speed
Description Tool reverse rotation speed