Docomo FOMA D851IWM, User Manual

Page: 49 / 460

47
Be
fo
re
Us
in
g
D8
5
1
iWM
1
f
(for over 2 seconds)
INFORMATION
● Calls may be cut off even when is indicated and you are not moving.
●
When Reset Call Cost is set to ON , entry of the PIN2 code is required.
●
In the following cases, if you do not press any keys for about 90 seconds, the display disappears (except while
shooting with the camera, etc.). It is the same also during a voice call. The display appears again if there is any
key operation or incoming call.
･
When Turn light on is set to other than Always in Display Light Setting
･
During charging (when Turn light on is set to other than Always , and AC adapter connected is set to Terminal
settings in Display Light setting)
Switching to English display
Select Language
1
m8272
2
Press
2
･
To switch to Japanese display:
1
INFORMATION
● The setting information is saved to the UIM.
Setting the date and time
Date and Time Setting
The time setting can be performed in two ways: obtaining the time information from DoCoMo
network to adjust the time setting of your FOMA terminal, or manually entering the current time to
your terminal.
1
m851
2
Select each item to set
Turning the power off
Default Japanese
Default Auto time adjust: ON Offset:
+,
00h00m
Auto time adjust
： Set whether to perform the automatic time correction.
･
To enter the date and time manually, set Auto time adjust to OFF.
Offset
： Specify the amount of time advance (+) or delay (-) so that your terminal’s clock
advances from/delays to the time obtained for a given length of time.
･
Enter the time between 00h00m and 23h59m.
･ Prefix 0 if the time and/or minute is single digit (0 to 9).
･
When you set
Auto time adjust
to
ON
,
Offset
can be set.
Date
and
Time
cannot be set.
S
e
le
ct
La
ngu
ag
e
Next
MP#3̲E.book 47 ページ ２００６年３月８日 水曜日 午後５時１８分