Docomo FOMA D851IWM, User Manual

Page: 433 / 460

4
last access to the audio memory without connecting
FOMA terminal to a PC.
･
Communication such as call or i-mode can not be
used.
･
The call indicator flashes.
･
Click on the task tray and click
USB 大容量記
憶装置デバイス−ドライブ (E:) を安全に取り外し
ます
(Release safely the USB large memory
device-Drive E: * 1 ) to quit operation of the audio
memory.
*1 The character to be assigned to a drive varies
by the system of PC.
Connecting using the included USB cable
Connect by using the included USB cable.
a
Open the cover on the FOMA terminal’s
external connection terminal
b
Insert one end of the USB cable into the
FOMA terminal’s external connection
terminal until it clicks
c
Insert the other end of the USB cable into the PC
USB connector
･
When a PC and FOMA terminal are connected
in the communication mode,
appears on the
display of FOMA terminal.
･
If you connect FOMA terminal to a PC in the
communication mode before installing the
communication configuration file, Windows may
automatically detect that the USB cable has
been inserted, request to install a driver, and
the wizard screen will be displayed. In that
case, remove FOMA terminal and click
キャン
セル
(Cancel) to exit the wizard.
■
Removing the USB cable
Press the release buttons on both sides of the
connector for the FOMA terminal and pull it out.
Pull the connector for PC out from the side of PC.
･
ALWAYS press the release buttons while
removing the connector from the FOMA
terminal. Pulling on the connector with undue
force can cause damage.
■
Connecting while charging
FOMA terminal can be connected using a desktop
cradle D01 (optional) during the charging.
However, charging time becomes longer.
INFORMATION
● Do not remove the USB cable during data
communication as it may result in malfunctioning or
failure of the FOMA terminal or PC, or a loss of data.
● You can also connect the FOMA terminal to a PC
with the FOMA USB cable (sold separately) and
install data settings files and perform data
communication, using the same procedures as
when the included USB cable is connected.
Installation of the communication
configuration file (driver)
Install the communication configuration file on a PC
before connecting FOMA terminal to a PC to
perform communication in the communication mode.
･
When FOMA terminal is connected with PC in the
audio memory mode, installation of the
communication configuration file is not required.
Installing the communication configuration file
Before operation, read “Before installation/
uninstallation”
☛
P3
･
Make sure to connect FOMA terminal to a PC
after performing Steps 1 to 3.
1 Insert the included CD-ROM into a PC
The
ソフトウェアのセットアップ
(Software
Setup) screen is displayed.
2 Click
通信設定ファイル
(Communication
configuration file)
3
Click
はい
(Yes)
A screen requesting to connect FOMA D851iWM
to a PC is displayed.
4 Connect the FOMA terminal to a PC
A progress screen for installation is displayed
and automatically completed.
･
Connect the FOMA while the power is on.
･
Proceed to
通信設定ファイルを確認する
(Check communication configuration file), and
check the type and name of the device installed.
Release button
Connector
(This side up)
USB connector
Next
Manual for Data Communication.fm 4 ページ ２００６年２月１０日 金曜日 午後７時３９分