Interface Provisioning
250-0800-06, Version A
41
D I T E C H N E T W O R K S
w w w . d i t e c h n e t w o r k s . c o m
3
Interface
Provisio
nin
g
Packet Voice Processor Commands Manual
describes the process for provisioning a Gigabit Ethernet media port on the
Interface Processing card.
INTERFACE <media-port> SET <admin-
state>
Sets the media port administrative state.
The required minimum access level is WRITE for this
command. For additional command information, see
INTERFACE <media-port> STATS [SHOW]
Show media port statistics.
The required minimum access level is READ for this
command. For additional command information, see
INTERFACE <media-port> STATS CLR
Clear media port statistics.
The required minimum access level is WRITE for this
command. For additional command information, see
INTERFACE <media-port> QOS-REPORT
[HIST <bin>] [SHOW]
Generate Experience Intelligence™ (EXi) report for
media interface.
The required minimum access level is READ for this
command. For additional command information, see
Table 3-6 Media Ports Provisioning
Step
Task
Description
1
Access the Packet Voice Processor
system.
Establish a connection to the active Interface
Processing card.
The process for connecting to the management port
is described in
Section 2.2, “Connecting to the PVP”,
2
Enter the INTERFACE [SHOW]
command.
Enter this command to to view the factory created
media port names, as well as their current status (in-
service or out-of-service).
for additional
command information.
3
Enter the INTERFACE <media-port>
[SHOW] command.
Enter this command to view the current media port’s
configuration.
for additional
command information.
4
Enter the INTERFACE <media-port> SET
command.
Enter this command to begin provisioning the media
port parameters.
for additional
command information.
Table 3-5 Media Ports Provisioning Commands (Continued)
Command
Description
