DITECH Packet Voice Processor, Command Manual

Page: 132 / 175

98 250-0800-06, Version A
D I T E C H N E T W O R K S
w w w . d i t e c h n e t w o r k s . c o m
General Commands
Packet Voice Processor Commands Manual
Table 9-4 describes the INVENTORY SHELF command output.
9.8.1 INVENTORY CARD Command
The INVENTORY CARD command displays the inventory information for a card or
all the cards in the Packet Voice Processor shelf. The minimum access level for this
command is Read. The command syntax is as follows:
INVENTORY CARD [<slot>]
9.8.2 Card to Slot Location
Because of software requirements and the different Packet Voice Processor card
backplane connections, each type of card must reside in a specific type of card slot
within the shelf. Figure 9-1 on page 99 displays a shelf chassis schematic with all 14
slots housing the different Packet Voice Processor card types. The front and rear
card slots are labeled with a number and card type.
Table 9-3 on page 99 describes which cards are housed in which slots.
Note Installing the wrong Packet Voice Processor card in a shelf slot will not cause any
damage to either the card or shelf, but the card will not activate.
Warning In a non-redundant Switch Control card configuration (only one Switch Control card
in the shelf), the single Switch Control card must be installed in shelf slot 1. For
additional information about card to slot placement, refer to
Table 9-3 on page 99 .
A Packet Voice Processor system configuration with 2 Switch Control Cards requires
their placement in slots 1 and 2. A Packet Voice Processor system configuration with
2 Interface Processing cards requires their placement in slots 4 and 6. A Packet
Voice Processor system configuration with Application Processing cards requires
their placement in slots 8 and 10.
Table 9-2 INVENTORY SHELF Command and Output
Command Output Description
Serial Number Factory created serial number.
Assembly Part Number Factory created assembly part number.
Assembly Hw Revision Factory created hardware revision number.
Top Assembly Part Num Factory created top assembly part number.
Top Assembly Revision Factory created top assembly revision number.
CLEI Common Language Equipment Identifier codes assigned by Telcordia to
provide standard method of identifying telecommunications equipment.
Warranty Expires Warranty expiration date for card.