Dimplex WPM EconPlus, Installation And Start-Up Instructions For Technicians

Page: 81 / 144

EN-37
Special accessories 13.5
Englis
h
13 Special accessories
13.1 Remote control
A remote control adds convenience and is available as a special
accessory. Operation and menu navigation are identical to those
of the heat pump manager. Connection is made using a 6-core
telephone cable (special accessory) with modular plugs. NOTE
In the case of heating controllers with removable control panels (see
Chap. 3.2.1 on p. 4 ), the operating element can also be directly used as a
remote control.
13.2 Remote Diagnostic System (FDS)
The remote diagnostic system ( F ern D iagnose S ystem - FDS)
was developed to enable access to the heat pump manager via
PC. In combination with an “Internet-compatible” PC and the
separately available hardware packages, the software enables
the user settings to be read out and changed as required. The
software is programmed to allow a constant exchange of data
between the heat pump manager and the PC. Changes are
possible both at the heat pump manager and in the program.
The software is started via an Internet browser on the PC and
has been optimized for the Windows 2000 and XP operating
systems.
Two versions are available:

Remote diagnostics on-site (e.g. with a laptop): L ocal
D iagnostic S ystem (LDS). Direct connection of the PC cable
via the LDS hardware package to the heat pump manager
(WPM).

Remote diagnostics via a modem connection: R emote
D iagnostic S ystem (RDS). RDS is a useful tool for checking
the operation of a remotely located plant and for adjusting
the user settings on the heat pump manager.
13.3 Room climate control station
With cooling using panel heating/cooling systems, regulation is
carried out according to the room temperature and humidity
measured by the room climate control station.
This is done by setting the desired room temperature on the heat
pump manager. The minimum possible cooling water
temperature is calculated from the room temperature and
humidity measured in the reference room. The control response
of the cooling system is influenced by the currently measured
room temperature and the set room set temperature.
Fig. 13.1: Room climate control station
13.4 Building management technology
The heat pump manager can be connected to a building
management system network via supplementation of the
relevant interface plug-in card. The supplementary installation
instructions of the interface card must be consulted regarding the
exact connection and parameterisation of the interface. The following networkconnections are possible with the heat
pump manager:
 Modbus
 EIB, KNX
 Ethernet
13.5 Thermal energy meter
A maximum of 1 thermal energy meters can be connected to the
heat pump manager for thermal energy measurement. Available
thermal energy meters are the WMZ25 and the WMZ32. The
supplementary installation instructions of the thermal energy
meter must be consulted regarding its installation and
parameterisation.