Digital Link DL600E, User Manual

Page: 50 / 147

3-16 DL600E E1 Data Multiplexer UserÕs Guide
Configuring the Data Port
To conÞgure a data port
,
use
Menu-5 Data Port ConÞguration
.
Set the parameters for the local and remote units.
SW Ver 1.0 MIB Ver 1.1 Digital Link DL600 Encore 4/22/95
HW Ver A Menu-5 Data Port Configuration 2:43:58
Local: OAHU Remote: MAUI
Loss MODE Format Clock Loss MODE Format Clock
DATA1 NONE DTE X.21 SCTE NONE DTE X.21 CTE
DATA2 NONE DTE X.21 SCTE
DATA3 NONE DTE X.21 SCTE
DATA4 NONE DTE X.21 SCTE
0-SNMP Config. 1-Main Status 2-Data DTE Status 3-Reports 4-Main Config.
5-Data Port Config. 6-Timeslot Config. 7-Alarm I 8-Alarm II 9-Diagnostics
Type Arrow keys to move the selection, RETURN to change a selection
or type 0 through 9 for a new menu:
Figure 3-3 Menu-5 Data Port ConÞguration
The example in Figure 3-3 shows the local DL600E unit with four data
ports in use. The remote unit is a DL600E unit with one data port.
The Data Port parameters and their options are:
Loss
Ñ DTR (Data Terminal Ready), RTS (Request to Send) or NONE
(DefaultÑ RTS)
Select the criteria for detecting loss of signal on the d ata port. The
loss appears when detected by the DL600E unit.
MODE
ÑDTE or DCE (DefaultÑ
DCE)
ConÞgure the data port as a DTE (Data Terminal Equipment) or a
DCE (Data Circuit Equipment). Each requires a different cable.
When DCE , both SCT and SCR are derived from a single smooth
clock source requiring the synchronization of the transmit and receive
directions, each directions derived from the same timing source.
When DTE , the data port ignores the SCT signal and uses SCR to time
both the send and receive signals.