3–12
DECbridge 500/600 Problem Solving
5. Use the small plastic handles on the power supply module to pull it forward out
of its backplane connector, then lift the power supply module to remove it.
3.3.4.2
Replacing the Power Supply
To replace the power supply module, refer to Figure 3–5 and follow these steps:
1. Make sure that power is removed from the bridge and the interface cables are
disconnected (Section 3.2).
2. Make sure the ESD ground strap is attached.
3. Make sure the insulator is in place between the power supply and card cage.
Then, place the power supply module on top of the card cage, aligning its
connector with the backplane connector.
Figure 3–5:
Power Supply Removal and Replacement
