IPsec parameters
Digi TransPort User Guide
421
IKE parameters
The
Configuration > Network > Virtual Private Networking (VPN) > IPsec > IKE
folder opens
to list configuration pages for
IKE 0
and
IKE 1
with a separate page for IKE Responder. The
IKE 0
instance can be used as an IKE initiator or as an IKE responder, while IKE 1 can only be used as an
initiator. The
IKE 0
and
IKE 1
pages are used to set up the
IKE 0
and
IKE 1
initiator parameters as
required. The
IKE Responder
page is used to set up the responder parameters for
IKE 0
.
IKE Debug parameters
Enable IKE Debug
Enables IKE debugging to be displayed on the debug port.
Debug Level
Sets the level of IKE debugging. The options are:
• Low
• Medium
• High
• Very High
Debug IP Address Filter
Used to filter out IKE packets with particular source or destination IP addresses. The format of
this parameter is a comma-separated list of IP addresses. For example, to exclude the capture
of IKE traffic from IP hosts
10.1.2.3
and
10.2.2.2
, enter
10.1.2.3,10.2.2.2
for this parameter.
Conversely, you may wish to only capture traffic to and from particular IP hosts. To do this, use
a tilde (
) symbol before the list of IP addresses. For example, to only capture packets to and
from IP host
192.168.47.1
, enter
~192.168.47.1
for this parameter.
Forward debug to port
When enabled, the IKE debug is sent to debug serial port.
