Diehl Metering SCYLAR INT 8, Installation And User Manual

Page: 7 / 71

Seite 7 von
71
All work must be performed only by technically trained personnel:
 installation and repair work
 work on the electronic circuits
Safety equipment
Safety equipment must be provided if required.
 E.g. install stop valves before and after the connected flow sensor to simplify removal and
installation.
Warranty
 Obtain the manufacturer’s approval before carrying out modifications, repair work or changes
during the warranty period.
 Use only genuine parts or parts approved by the manufacturer.
2.2.3 Obligations of trained personnel/user
 Observe all instructions in the Installation and User Guide and on the device that are relevant
to handling the calculator.
 Use safety equipment if necessary.
 Always disconnect the calculator from the electrical supply before carrying out repair work.
2.3 Specific hazards
DANGER
Do not touch live parts during installation work.
Risk of serious injuries or death!

The calculator installation is only to be performed by an installation and/or
electrical contractor.
 Personnel must be trained in the installation of medium-voltage electrical
equipment (up to 1000 V).
WARNING
Electrostatic discharge.
Risk of damage to calculator and particularly electronic components, for which
no liability is accepted!

Observe the relevant ESD (electrostatic discharge) regulations.
CAUTION
Electric and magnetic fields.
Risk of interference with electronic components in the calculator!

Do not install the calculator or the input/output cables near heavy electrical loads
or their cables.
 Maintain the exact separation. This depends on the magnitude of the voltage and
current of these loads.
 Consult a suitable expert in the event of doubt.