Diehl Metering SCYLAR INT 8, Installation And User Manual

Page: 44 / 71

Seite 44 von
71
WARNING
Electrostatic discharge.
Risk of damage to meter and particularly electronic components, for which no
liability is accepted!
Observe the relevant ESD (electrostatic discharge) regulations. No liability is
accepted for damage (especially to electronic components) resulting from failure to
comply with the ESD regulations.
1. Remove the seal from the calculator housing and open the calculator by releasing the side catches.
2. Take the top part of the calculator and turn it so that the inside of the calculator is facing you. You
can simplify installing the modules by using the two openings in the top part to place this on the
bottom part (Fig. FF, item 1).
Fig. FF Installation position of top part
1 Openings in the top part for placing on the bottom part
3. Insert the module in the relevant slot (Fig. EE, page 44), secure with the fixing lugs and carefully
connect the pre-formed ribbon cable at both ends.
4. Now remove the top part from the installation position, turn it and replace it in the correct position
on the bottom part of the calculator.
5. Check the calculator for correct operation before sealing the housing cover. The calculator is
equipped with automatic detection for detecting which module is inserted in each slot (port). The
detection result is shown in loop 3 of the display in two different sequences (windows) for port 1
and port 2. This display automatically changes between “Port 1” and “Port 2” and the relevant
module number (module code).
6.2.1 Display of the slot configuration
The Calculator SCYLAR INT 8 is equipped with an automatic detection which module is mounted in
which slot (port). This detection will be shown in the display in loop 3 in two different sequences for port
1 resp. port 2. The two sequences will be shown alternating.
1
1