21
EN
3.2
Adjusting the cardan shaft
The length of the cardan shaft has been rated in the
factory to fit practically all types of tractors. It will only
need to be adjusted in exceptional cases for individual
tractors. Check the length of the cardan shaft as follows
before using it for the first time (fig. 3-3):
Danger!
Work may only be carried out with the
implement at a standstill! Shut down the
engine and remove the ignition key!
z
Pull the cardan shaft apart and push both halves
on the p.t.o. shaft.
z
Hold the two shaft halves next to each other and
check that when the Rotary Tedder is raised and
lowered, or when going round bends,
- there is an overlap of at least 150 mm (b)
and
- the cardan shaft does not come into contact
with the block (minimum clearance
(a) = 20 mm).
z
If the cardan shaft has to be shortened, cut off the
sliding and protecting tubes by the same amount.
z
Deburr the tube ends, remove any loose chips,
grease the contact points well.
z
After shortening the cardan shaft, the minimum
overlap and the minimum clearance has to be
verified if a different tractor is used.
a
b
Fig. 3-3
Summary of Contents for CondiMaster 6831
