17
EN
9. Keep away from the rotating unit. No-one may be in the immediate vicinity of the Rotary Tedder
when the implement is running! Before switching on the p.t.o shaft, ensure that no-one can be hit
by the rotating unit!
10. The prescribed p.t.o. shaft speed n
max
= 540 rpm must not be exceeded!
11. Do not step between the tractor and the Rotary Tedder. Risk of being squeezed and crushed!
12. When actuating the power lift, stay out of the lifting area of the three-point linkage.
13. Check all bolted joints and, if necessary, tighten them after approx. 5 operating hours. Observe
torque!
14. When parking the implement, place the cardan shaft into the support!
1.12 Regulations for travelling on public roads
Only valid for the Federal Republic of Germany!
The German road traffic licensing regulations (Straßenverkehrs-Zulassungs-Ordnung - StVZO) specify
that all mounted and trailed implements have to be equipped with rear reflectors and electric lighting. In
order to draw attention to the sharp corners and edges, mark the outer edges on the front and rear of
the implement with red and white striped warning boards so that they are clearly visible from the front
and the rear.
When using public roads, the legal provisions on width marking, lighting etc. are to be observed. If the
implement exceeds the prescribed maximum width, special permission is to be applied for.
Also observe the legal provisions in the Instructions for mounted implements (Merkblatt für Anbaugeräte).
These instructions stipulate for example that for each type of load the front axle load must be at least
20 % of the tractor tare weight.
Summary of Contents for CondiMaster 6831
