DEUTZ-FAHR CondiMaster 6831, Operation Manual, Page: 15 / 38

13
EN
9. Couple the implement to the tractor at the prescribed position and secure according to the instructions
given in this manual! Proceed with special care when mounting and removing the implement on/
from the tractor!
10. When mounting or dismounting the support devices, make sure that they are in the appropriate
prescribed position in order to ensure stability! Only deposit the implement on level and solid
ground.
11. Ballast weights are only to be installed to the points designed for this purpose!
12. Do not leave the engine on within closed spaces (indoors)!
13. Before start up and operation, inspect the area around you. Make sure that no-one, (especially
children) is in the danger area! Good visibility is essential!
14. No-one (other than the driver) is allowed on the implement during transport!
15. Always select the speed according to travel conditions. Avoid sudden turns when travelling up-hill,
down-hill or across a slope!
16. Trailed implements and ballast weights, influence the driving of the implement and the steering and
braking performance! Make sure there is sufficient steering and braking capacity!
17. When negotiating curves take notice of the implement’s overhang and/or flywheel mass!
18. Make sure all protective devices are installed and in position before operating the implement!
19. Keep clear of the working and danger area of the implement!
20. Keep clear of the swinging/turning area of the implement!
21. Caution when working on implement elements operated by additional driving systems (e.g.
hydraulics). There are squeezing and shearing points!
22. Secure the implement prior to leaving the tractor. Mounted implements have to be lowered completely
to the ground. Stop the engine and remove the ignition key!
23. No-one is allowed to step between the tractor and implement as long as the vehicle is not secured
against unintentional movement by means of the parking brake and/or wheel chocks!
24. Observe the permissible axle load and total weight of the implement as well as the permissible
transport dimensions!
1.8.2 Trailed implements
1. Prior to coupling or uncoupling implements to/from the tow bar, all controls of the tractor hydraulics
have to be positioned in such a way that any unintentional lifting or lowering of the implement is
ruled out!
2. It is essential that the hitch category of the implement matches that of the tractor!
3. There is danger of squeezing or shearing in the area of the tow bar!