Desoutter CVIL II, Operator'S Manual, Page: 56 / 80

01/2018 56 / 80
6159933780
Issue no: 09
CVIL II
10 - PRINTING FORMAT FOR
TIGHTENING RESULTS
10.1 - PC2 format
Char
number Designation
1 char. <CR>
2 range or cycle number
2 fastener number
3 «T=+»
5 torque in 1/10 of Nm
1 <LF>
1 " "
1 <CR>
2 range or cycle number
2 fastener number
3 «A=+»
5 angle in 1/10 of degree
1 <LF>
1 " "
1 <CR>
2 range or cycle number
2 fastener number
3 «TR=+»
5 torque rate in 1/1000 Nm/dg
1 <LF>
1 " "
Example of result:
<CR>0109T=+00400<LF> <CR>0109A=+01200<LF>
<CR>00580<LF>
The last result in the list ends with <LF><LF> instead of
<LF>""
10.2 - PC3 format
Char
number Designation
1 char. A (frame type)
3 station number (1 to 250)
3 port number (1 to 32)
1
configuration (A to O correspond to
configurations 1 to 15)
1
Z (system identifier)
1
char. A (frame type)
1
report code (see chart below)
6
date (year, month, day)
6
time (hour, minute, second)
8
torque
5
angle
1
<CR>
1
Checksum (modulo sum 256 of the previous
characters) not calculated for the moment
1 <LF>
The last result in the list ends with <LF><LF> instead of
<LF>
Report code: ASCII code 0100 :
X X X X
1 2 3 4
Legend
1 1 = max. angle
2 1 = min. angle
3 1 = max. torque
4 1 = min. torque
According to the various combinations, the following
characters will be obtained:
@ accept torque accept angle If "NOK:SCY=0"
is set to "Yes"
O accept torque accept angle If "NOK:SCY=0"
is set to "No"
A min. torque accept angle
B max. torque accept angle
D accept torque min. angle
E min. torque min. angle
F max. torque min. angle
H accept torque max. angle
I min. torque max. angle
J max. torque max. angle
0x00
on servodrive fault
or spindle belonging to reject group
or cycle start drop
or cycle not completed for spindle
or transducer fault
Example of result:
A001001BZ@92120811021500041.7500121<CR>
<CS><LF>