DENTSPLY Multimat Easy, Instructions For Use Manual

Page: 52 / 154

52
Multimat
Easy
6 Controls
‹
Turning on the unit/Starting a firing program
1. Turn on the unit with the
on off
key. The controller will
be started and performance self-test.
2. The main menu will be shown, indicating the program
last run.
3. Move the firing platform down using the
Í
key. Place
the firing object with firing base and firing support on the
firing platform.
4. If you wish to start the program currently shown, press
the
start stop
key. The green LED will be lit.
‹
Designing and starting your own firing program
Note:
If you try to enter a parameter outside the valid
range (see “Firing parameters” ), you will hear a long beep
tone, and the cursor will jump to the parameter you need
to change. You have 60 seconds to enter each parameter.
1. The
main menu
is shown.
2. Press the P key. The program number will be activated.
Enter the desired program number via the keypad or the
+ and – keys.
3. Press the
4
key. The cursor will jump to the next field,
Pre-heating temperature . Enter the desired value via
the keypad or the + and – keys.
4. Press the
4
key. The cursor will jump to the next field,
Heating rate
. Enter the desired value via the
keypad or the + and – keys.
5. Press the
4
key. The cursor will jump to the next field,
Pre-set firing temperature . Enter the desired value via
the keypad or the + and – keys.
Degudent KBO
V1.00 ...booting...
Selftest