DENTSPLY Multimat Easy, Instructions For Use Manual

Page: 46 / 154

46
Multimat
Easy
5 Controls
‹
Control panel
All
parameters
are shown on the display and can be
entered or edited here. Parameters are entered exclusively
via the keys of the control panel (membrane keyboard).
Use the keys of the membrane keyboard to make your
entries, which will be reflected in the display (see
“Display” ),
or to switch between different
menus
(see
“Moving through
the menus/Menu overview” ).
The control panel keys have the following functions:
(1) Display . Shows all firing parameters (see “Display” ).
(2) on off key. Turns the controller on or off. When turned
off, the firing chamber will be closed by the firing
platform, and the unit will be in standby mode (vacuum
and standby temperature).
(3)
ÈÍ
keys. Move the firing platform upward down.
(4) * key. Activate fast cooling using the vacuum pump.
(5) Menu key. Calls the configuration menu; from there,
additional submenus for system configuration can be
invoked (see
“Moving through the menus/Menu over-
view” )
( 6) P key. Runs a specific program directly.
(7) S key. Saves the parameters shown on the display.
(8)
34
keys.
For moving within menus (See
“Moving
through the menus/Menu overview” )
(9) +– keys. Increases/decreases parameter values
(10) ESC key.
Returns without applying changes
(11) ENTER key.
Confirms and applies changes
(12) Numeric keypad.
For entering parameter values,
digits 0 to 9.
(13) start stop key. Starts/stops the firing program.
(14) Green LED.
Lit while firing program is running.
2
1 14
3
4
5 6 7 8 9 10 11
12
13