Denso HS-4535G, General Information Manual

Page: 35 / 56

Chapter 3 Specifications of the Robot Unit
29
■ To be applied to all models of the HSS-G series (Overhead-mount type)
(1) To horizontally traverse the robot arm at high speeds, teach the robot so that Z
axis comes to be as close as possible to its upper end.
(2) To stabilize positioning of Z axis near its lower end, the following maximum speed
limiting control is automatically provided for J1 and J2 axes depending on the
Z-axis coordinate value, only when the robot is moved under PTP control.
The positioning time of J1 and J2 axes becomes longer according to the
maximum speed limit shown below.
[Movement time in J1/J2 positioning time graphs (sec.)]
x 100 (sec.)
Max. speed limit
For example, when the robot arm moves by SP100 from the start point (Z-axis
coordinate -651 mm) to the target point (Z-axis coordinated -751 mm), the
maximum speed limits are as follows:
91 when Z-axis coordinate is -651 mm
50 when Z-axis coordinate is -751 mm
At this time, the maximum speed is the smaller value (at the lowest end) of 50.
Z-axis coordinate (mm)
HSS-G: Series Maximum Speed Limit on the J1 and J2 (PTP control)
There i
no sp
Max.
sp
eed
limit (C
onve
rted
to
SP
va
lue)