Denso BHT-1170BWB-CE, User Manual

Page: 155 / 219

143
Barcode Handy Terminal/2D code Handy Terminal
4.7 Scanner Reading Parameters
The setup menu for the scanner reading parameters can be launched from the System Properties menu or Hard Test
menu.
4.7.1 Top Menu
use the settings: Enables or disables the menu.
Default is unchecked (disabled).
Read Mode: Sets the scanner reading mode.
Read Code: Sets up the readable codes.
Data Edit: Edits data read by the scanner.
Tap the "OK" button to make the new settings take effect and exit the menu.
The new settings are stored in the registry.
Tap the "Cancel" button to abort the changes and exit the menu.
4.7.2 Read Mode
The Read Mode menu is used to set the scanner reading mode.
Select one from the following 4 modes.
Auto Off: Auto-Off mode
Momentary: Momentary switching mode
Alternate: Alternate switching mode
Continuous: Continuous reading mode
Beeper:
Activates the beeper and or vibrator when the scanning is
completed.
Auto-off mode :
The illumination LED turns on when the trigger key is pressed, and turns off when the trigger key is
released or a code is read.
The illumination LED turns on continuously for a maximum of 5 seconds while the trigger key is pressed.
When the illumination LED turns off after 5 seconds has elapsed, press the trigger key again.
The BHT reads a code while the illumination LED is turned on.
When a first code is read successfully or the code device file is closed, the BHT no longer reads a code.
In order to read the next code, read out the scanned data from the code buffer, then press the trigger key
again.