DeltaOHM HD31, Operating Manual

Page: 54 / 154

HD31
- 54 -
V1.6
4. Using
S
and
T
, select the interval for the automatic logging
or the "MANUAL” item to set the manual logging.
Note : the current setting appears in white, while the other
available settings are shown in yellow to highlight that they
are not the current setting.
By selecting an interval exceeding or equal to 60 seconds
(120 seconds if the CO
2
probe is connected), the indication
"SLEEP AVAILABLE" appears under the interval value, to re-
mind that the Auto-off of the instrument can be enabled be-
tween two logging instants (see paragraph 7.5).
5. Select OK ( F3 key) to confirm, or ESC to exit without changing the value.
6. The instrument returns to the PERIOD menu item, press ESC twice to exit the menu and re-
turn to the measurement mode.
7.2 S
ELECTING THE MEASUREMENT LINES FOR LOGGING
If measurement lines are not explicitly selected for logging, the logging activation generates
the storage of all the measurement listed on the display (all the measurement lines which can
be scrolled with the
S
and
T
keys, and not only the three measurements displayed at that
moment). Logging can be performed only for some measurement lines, by explicitly selecting
them.
Attention: you can log a maximum 16 measurement lines; if more than 16 lines can
be displayed, only the logging of the first 16 lines of the list will be performed.
To select a measurement line for the logging:
1.
In measurement mode, select the desired measurement line using
S
and
T
.
2. Press SELECT to display the LOG
command in the command bar,
then select the command by press-
ing the
F1 key.
3. Select the SEL command by pressing the F2 key.
Note : the SEL command is disabled if logging is in progress.
5. The L symbol is displayed in the upper part of the measurement
line, to indicate that the line is selected for logging.
To deselect the measurement line for logging, select again the SEL command ( F2 key): the L
symbol disappears.
Select in the same way all the measurement lines you want the logging to be performed.
Press
ESC to exit the LOG menu.
Symbol "L"