Delta Electronics HMC Series, Manual

Page: 73 / 108

HMC Take-out Robot for Injection Molding Machine
June, 2015
73
(b)
Detect time: When the system does not receive the signal within the setting time,
an alarm will occur. When the detection time is not set to 0, a window of time
delay will pop up and an alarm will occur.
To open and close the safety door again will clear the alarm and resume the
operation. Press [Alarm Confirm] ([F10]) to stop the operation.
3.5.3 Procedure
 Starts
:
Apart from the first cycle, each cycle starts from this command when it is in
auto operation. Commands before [Starts] will be regarded as the initial commands
for auto operation.
 End
:
When executing this command, the cycle is over.