2
SCv360 Expansion Enclosure Installation
This chapter describes how to install an SCv360 expansion enclosure.
Safety Precautions
Always follow these safety precautions to avoid injury and damage to Storage Center equipment.
If equipment described in this guide is used in a manner not specified by Dell, the protection provided by the equipment could be
impaired. For your safety and protection, observe the rules described in the following sections.
NOTE: See the safety and regulatory information that shipped with each Storage Center component. Warranty
information is included as a separate document.
Installation Safety Precautions
Follow these safety precautions when installing an SCv360 expansion enclosure:
Caution
Equipment exceeds 90 kg (200 lb). Use appropriate lifting methods when installing an
SCv360 expansion enclosure.
•
You can install the expansion enclosure chassis without using a mechanical lift if you remove the drives, cooling fans, power
supply units (PSUs), and enclosure management modules (EMMs) from the chassis before installing it.
You must use a mechanical lift to install the expansion enclosure chassis if you do not remove the drives, cooling fans, PSUs, and
EMMs from the chassis.
•
Dell recommends that only individuals with rack-mounting experience install an SCv360 expansion enclosure in a rack.
•
When installing multiple expansion enclosures in a rack, fill the rack from the bottom up and empty the rack from the top down.
•
The rack construction must support the total weight of the installed expansion enclosures. The design should incorporate
stabilizing features suitable to prevent the rack from tipping or being pushed over during installation or in normal use.
•
To prevent the rack from tipping, slide only one expansion enclosure out of the rack at a time.
•
Make sure that the expansion enclosure is always fully grounded to prevent damage from electrostatic discharge.
•
When handling the expansion enclosure components, use an electrostatic wrist guard or a similar form of protection.
Electrical Safety Precautions
Always follow electrical safety precautions to avoid injury and damage to Storage Center equipment.
WARNING: Disconnect power from the expansion enclosure when removing or installing components that are not hot-
swappable. When disconnecting power, first power down the storage system using the storage client and then unplug
the power cords from the power supplies in the storage system and expansion enclosure.
•
Provide a suitable power source with electrical overload protection. All Storage Center components must be grounded before
applying power. Make sure that a safe electrical earth connection can be made to power supply cords. Check the grounding
before applying power.
•
The plugs on the power supply cords are used as the main disconnect device. Make sure that the socket outlets are located near
the equipment and are easily accessible.
SCv360 Expansion Enclosure Installation
11