3–Adapter Management Applications
General Management with QConvergeConsole
66
CU0354602-00 L
d.
IP_Subnet_Mask [0.0.0.0]:
Type the appropriate subnet mask, and
then press ENTER.
e.
IP_Gateway [0.0.0.0]:
Press ENTER to accept the default.
f.
Enable IPv6 [off]:
Press ENTER to accept the default.
9.
On the options menu that appears, select
3, Save changes and reset HBA
(if necessary)
.
10. At the prompt for both ports, type
Yes
.
11.
To return to the Converged Network Adapter (CNA) iSCSI Configuration
menu, type
P
and press ENTER, and then type
P
and press ENTER again.
12. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select
4, Target Configuration
.
13. Select the same Converged Network Port you selected in
Step 6
.
14. Select
6, Add a Target
.
15. Complete the interactive list of settings as follows:
a.
IPv6 Target? [off]:
Press ENTER to accept the default.
b.
TGT_iSCSI_Name [ ]:
Type the iSCSI Qualified Name (IQN) of the
iSCSI target to connect to and then press ENTER.
c.
TGT_Port [3260]:
Press ENTER to accept the default.
d.
TGT_TargetIPAddress [0.0.0.0]:
Type the IP address of the target
and then press ENTER.
16. On the options menu that appears, select
12, Save Target/CHAP Changes
.
The iSCSI initiator is now configured to connect to the iSCSI target.
Configuring the Linux iSCSI Initiator
Use the QConvergeConsole CLI to configure the iSCSI initiator for Linux.
To configure a Linux iSCSI initiator:
1.
Access the QConvergeConsole CLI by typing
qaucli
in a terminal window.
2.
On the QConvergeConsole CLI Main Menu, select
2, Adapter
Configuration
.
3.
On the Adapter Type Configuration Selection menu, select
1, CNA
Configuration
.
4.
On the Converged Network Adapter (CNA) Protocol Type Selection menu,
select
1, CNA iSCSI Configuration
.
5.
On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select
3, Port IP Settings
.