Related links
Safety instructions
Before working inside your system
Installing the control panel
After working inside your system
Installing the control panel
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Keep the #2 Phillips screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
Steps
1.
Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
NOTE: Information tag lists system information such as Service Tag, NIC, and MAC address.
2.
If disengaged, install the vFlash connector/USB connector module into the control panel using the following steps:
a. Connect the control panel cable to the control panel.
b. Install the screws to attach the vFlash connector/USB connector module to the control panel.
Figure 90. Installing the vFlash connector/USB connector module
1. vFlash connector/USB connector module
2. screw (2)
3. control panel connector cable
3.
To install the information tag, push the information tag into the control panel slot.
4.
Connect all the applicable cables to the system board.
147
